Interinstrument comparison of remote-sensing devices and a new method for calculating on-road nitrogen oxides emissions and validation of vehicle-specific power

Emissions of nitrogen oxides (NOx) by vehicles in real driving environments are only partially understood. This has been brought to the attention of the world with recent revelations of the cheating of the type of approval tests exposed in the dieselgate scandal. Remote-sensing devices offer investigators an opportunity to directly measure in situ real driving emissions of tens of thousands of vehicles. Remote-sensing NO₂ measurements are not as widely available as would be desirable. The aim of this study is to improve the ability of investigators to estimate the NO₂ emissions and to improve the confidence of the total NOx results calculated from standard remote-sensing device (RSD) measurements. The accuracy of the RSD speed and acceleration module was also validated using state-of-the-art onboard global positioning system (GPS) tracking. Two RSDs used in roadside vehicle emissions surveys were tested side by side under off-carriageway conditions away from transient pollution sources to ascertain the consistency of their measurements. The speed correlation was consistent across the range of measurements at 95% confidence and the acceleration correlation was consistent at 95% confidence intervals for all but the most extreme acceleration cases. VSP was consistent at 95% confidence across all measurements except for those at VSP ≥ 15 kW t^?1, which show a small underestimate. The controlled distribution gas nitric oxide measurements follow a normal distribution with 2σ equal to 18.9% of the mean, compared to 15% observed during factory calibration indicative of additional error introduced into the system. Systematic errors of +84 ppm were observed but within the tolerance of the control gas. Interinstrument correlation was performed, with the relationship between the FEAT and the RSD4600 being linear with a gradient of 0.93 and an R² of 0.85, indicating good correlation. A new method to calculate NOx emissions using fractional NO₂ combined with NO measurements made by the RSD4600 was constructed, validated, and shown to be more accurate than previous methods.

Implications: Synchronized remote-sensing measurements of NO were taken using two different remote-sensing devices in an off-road study. It was found that the measurements taken by both instruments were well correlated. Fractional NO₂ measurements from a prior study, measurable on only one device, were used to create new NO_x emission factors for the device that could not be measured by the second device. These estimates were validated against direct measurement of total NO_x emission factors and shown to be an improvement on previous methodologies. Validation of vehicle-specific power was performed with good correlation observed.     

One-Component Spray Polyurethane Foam from Liquefied Pinewood Polyols: Pursuing Eco-Friendly Materials

The use of petroleum-derived products should be avoided regarding the principles of green and sustainable chemistry. The work reported herein, is aimed at the liquefaction of pine shavings for the production of an environmentally-friendly polyol suitable to be used in the formulations of sprayable polyurethane foams. The biopolyols were obtained in high yield and were used to replace those derived from fossil sources, to produce more “greener” polyurethane foams and therefore, less dependent on petroleum sources, since the polyol component was substituted by products resulting from biomass liquefaction. The partial and fully exchange of the polyols was accomplished, and the results compared with a reference foam. The foams were afterward, chemical, physical, morphological, and mechanically characterized. The complete replacement of polyether polyol and polyol polyester has presented some similar characteristics as that used as a reference, validating that the path chosen for the development of more sustainable materials is on the right track for the contribution to a cleaner world.     

Analysis and optimization on the biodegradable plate making process parameters using RSM-based Box–Behnken Design method

Journal of Material Cycles and Waste Management - The present research work focused on fabricating Biodegradable Plate (BD plate) composed of rice husk ash, bagasse and corn starch which is...     

Monitoring Biofilm Thickness Using A Non-Destructive, On-Line, Electrical Capacitance Technique

Abstact The present study was designed to evaluate indirect, non-invasive, on-line measurement of biofilm thickness using an electrical capacitance technique. Several assays were carried out and the results showed that, at a frequency of 1 kHz, electrical capacitance could be used to measure biofilm thickness indirectly (with a correlation coefficient of 0.9495). The reproducibility revealed by the assays was also highly satisfactory.However, in contrast to what was expected, there was an inverse relationship between electrical capacitance and biofilm thickness, i.e. electrical capacitance diminished with the increase in the biofilm thickness.The tests were also carried out at different frequencies (1 kHz, 10 kHz and 100 kHz)     

The Metallic Composition of Aerosols at Three Monitoring Sites in Korea During Winter 2002

In the present study, the distribution patterns of various metals were analyzed and compared using PM samples collected concurrently from three monitoring sites located in Korea (Seoul, Busan, and Jeju island) in December 2002. As these sites can represent metal pollution with different degrees of anthropogenic activities, their concentration levels were distinguished in a systematic manner in the order of Jeju, Busan, and Seoul. By comparing the present data sets with those measured previously from other locations in Korea and around the world, we attempted to diagnose the general status of elemental pollution on the Korean peninsula. Through an application of different statistical approaches, the major processes controlling elemental levels were assessed for each of the three study sites. The results indicated the importance of both crustal and anthropogenic sources in all sites with their relative roles varying significantly from each other. The results of the metal analysis data, when examined in relation to back trajectory analysis, confirmed that their concentration changes are affected quite sensitively with air mass movement patterns. The overall results of this study consistently indicated the contribution of a strong anthropogenic source area (e.g., China) to the observed metal concentration levels in the study area, but the strengths of such signals vary considerably across the Korean peninsula.     

Effects of Coastal Lighting on Foraging Behaviorof Beach Mice

Abstract:  Introduction of artificial light into wildlife habitat represents a rapidly expanding form of human encroachment, particularly in coastal systems. Light pollution alters the behavior of sea turtles during nesting; therefore, long-wavelength lights—low-pressure sodium vapor and bug lights—that minimize impacts on turtles are required for beach lighting in Florida (U.S.A.). We investigated the effects of these two kinds of lights on the foraging behavior of Santa Rosa beach mice (  Peromyscus polionotus leucocephalus ). We compared patch use and giving-up densities of mice for experimental food patches established along a gradient of artificial light in the field. Mice exploited fewer food patches near both types of artificial light than in areas with little light and harvested fewer seeds within patches near bug lights. Our results show that artificial light affects the behavior of terrestrial species in coastal areas and that light pollution deserves greater consideration in conservation planning.     

Introduced and cryptogenic species in Port Phillip Bay, Victoria, Australia

Port Phillip Bay (PPB) is a large (1,930 km²), temperate embayment in southern Victoria, Australia. Extensive bay-wide surveys of PPB have occurred since 1840. In 1995/1996 the Commonwealth Scientific and Industrial Research Organization (CSIRO) Centre for Research on Introduced Marine Pests (CRIMP) undertook an intensive evaluation of the region with the aims of developing a comprehensive species list of native and introduced biota and contrasting previous bay-wide assessments with a current field survey in order to detect new incursions and discern alterations to native communities. Two methods were used to meet these aims: a re-evaluation of regional museum collections and published research in PPB to identify and determine the timing of introductions; and field surveys for benthic (infauna, epifauna and encrusting) organisms between September 1995 to March 1996. One hundred and sixty introduced (99) and cryptogenic (61) species were identified representing over 13% of the recorded species of PPB. As expected, the majority of these are concentrated around the shipping ports of Geelong and Melbourne. Invasions within PPB appear to be increasing, possibly due to an increase in modern shipping traffic and an increase in aquaculture (historically associated with incidental introductions); however the records of extensive biological surveys suggest that this may, in part, be an artefact of sampling effort. In contrast to Northern Hemisphere studies, PPB (and Southern Hemisphere introductions in general) have significantly different suites of successfully invading taxa. PPB is presented as one of the most invaded marine ecosystems in the Southern Hemisphere.Communicated by M.S. Johnson, Crawley     

Effect of deuterium-depleted water on reproduction of rainbow trout

During the artificial reproduction of salmonides, the fecundity can be increased either by improving the viability of spermatozoa, or by extending the time period during which a roe micropile remains open, thus allowing its fecundation. Practically, this can be achieved by the use of some fertilising techniques suitable for fish species. Here, we show that the reproduction of rainbow trout in a 1:1 solution of deuterium-depleted water and distilled water led to a significant increase in survival of roes during their embryonic development. Moreover, the addition of glucose and fructose into the deuterium-depleted fertilising solutions led to a further increase in roe survival during embryonic development. The increase in survival is mainly explained by an increase in the motility of spermatozoa.